PRODUCT / NOVOL
NOVOTEC 3190
One-component, air-drying styrenated alkyd gloss enamel for use over a specified compatible primer system.
Product enquiryBUILT FOR THE JOB
A gloss alkyd finish for a separate primer-and-enamel system
NOVOTEC 3190 is a one-component styrenated alkyd enamel that forms the finishing layer of an appropriate primer-and-topcoat system. Its gloss finish provides a separate finishing step after substrate preparation and priming.
Consider it alongside PROTECT 371 when developing an alkyd maintenance-painting schedule. The two products perform different roles: PROTECT 371 is the primer and NOVOTEC 3190 the enamel. Confirm compatibility, recoating intervals and the complete system before application.
Before you specify: Use a confirmed compatible primer and follow both technical data sheets. Operating hardness is not a return-to-service approval for abrasion, impact, immersion or loading waste into a container.
Manufacturer pack option; confirm current availability. Image dimensions do not establish the depicted container volume.
Packaging & supply
- 18 L
Base, hardener and thinner are separate products unless a complete kit is explicitly identified. Images are not a dimensional scale comparison.
Enquire about NOVOTEC 3190SPECIFY THE COMPLETE SYSTEM
System & application notes
One-component air-drying alkyd coating. No separate hardener is specified. Follow the TDS for permitted thinning and application method.
- Substrates
- Alkyd, polyurethane or epoxy undercoats prepared to their specification; old coatings and polyester laminates matted and degreased. Bare steel is not listed.
- Thinner
- THIN50,0–15% relative to topcoat; do not thin for airless application.
- Dry film
- 45–55µm per coat;1–2 coats.
- Application
- Pneumatic or air-assisted airless; mix thoroughly and remove skin. Climate+10…+35°C, RH≤80%, dry substrate≥3°C above dew point.
- Recoat/flash-off
- Recoat1–5h; intercoat flash-off5–10min. Preserve these as separate TDS instructions.
- Drying at20°C
- Dust-free30min; tack-free1.5h; operating hardness10h. Temperatures refer to coated elements.
- Gloss
- Approximately90 at60°.
Use a confirmed compatible primer and follow both technical data sheets. Operating hardness is not a return-to-service approval for abrasion, impact, immersion or loading waste into a container. Operating hardness at 20°C is 10 h; this does not establish full cure or permission to load a waste container.
MANUFACTURER DOCUMENTATION
Technical & safety data
Current English TDS linked by NOVOL at verification on 16 October 2026. Confirm the current regional SDS before use.
- AVERRA TDS · EN (PDF) ↗07/05/2020
AVERRA-branded technical data sheets retain the source technical data and issue dates. Safety data sheets remain the original manufacturer editions. Document language and regulatory jurisdiction are stated in each file. European SDS do not establish Canadian WHMIS compliance. Confirm the applicable local SDS and current revision before use.
Manufacturer: NOVOL. Averra supplies materials and helps clarify application requirements. Product listings do not establish military qualification, project approval or current stock. Use the exact approved system and its technical instructions.
Let’s talk about your project.Start a product enquiry